|
|
Item Posts
Sort Order
|
|
|
19999 Polaris sportman 500 4x4
|
|
Posted: 07/04/09
06:55 AM
|
|
Spring PIN
How do I get them out and in? Is there a special tool I need ?
I have bent two punches tring to drive one out on the front CV drive shaft. I started to drill on one last night. The drill bits are not HARD enought.
HELP HELP
Thank you
atcgmctruck@yahoo.com
|
|
|
|
ATOMANT
New User
| Posts: 44
| Joined: 06/09
Posted: 07/04/09
06:46 PM
|
|
Not sure why its so tough. I have some long tapered punches that should get it started. Probably once its out a ways it will come easier.
|
|
|
|
|
Posted: 07/05/09
10:17 AM
|
|
ATOMANT Thanks
I purchased some Titanum bit last night.These pin are not your every day spring pin they look like a peice of rolled spring steel to make a pin
|
|
|
|
|
|
|
Posted: 07/05/09
04:35 PM
|
|
They call them roll pin punches. They have a little nipple on the end and have a straight shaft
Heres my toys
YFZ450 "06" jet kit, zip tie mod, cam mod, sold
Raptor 350 "06" stock, sold
Predator 90 "06" stock, sold
|
|
|
|
ATOMANT
New User
| Posts: 44
| Joined: 06/09
Posted: 07/06/09
06:42 AM
|
|
I wouldnt drill it. If it goes crooked you will damage the housing. Like I said once you get it moving it should come out. I have a set of Snap on roll pin punches and even they will bend if the pin is too tight. Start it moving with a heavy duty taper punch with the small end large enough to get the pin at least part way out. Then switch to a smaller punch to drive it out.
|
|
|
|
|
|
|